Menvier Security TS400 Bedienerhandbuch PDF herunterladen (Seite 12)

b) Pull down the plastic clip at the bottom right hand corner of the PCB and gently

lift the PCB forward.

c) Repeat with the plastic clip at the bottom left hand corner of the PCB.

d) The bottom of the PCB will then swing forward and the whole PCB will come away

from the base.

3 Hold the base in the required position and mark the centre of the keyhole positions.

Remove the base, then drill and plug the holes. Note: Remember to allow enough

room to get the cover screw in to top of panel when mounting the base.

4 Re-position the base and secure to the wall with 3 x No. 10 1

⁄

" wood screws.

5 If a remote keypad is being fitted to the system, refer to page 16.

6 Re-fit the PCB assembly by aligning the top of the PCB into the 2 supports in the top

of the housing ensuring that the edges of the board sit between the 2 flanges, then

push the bottom of the PCB until it clicks in place.

7 Re-connect the AC leads to the transformer.

8 Connect the mains to the fused terminal block in the panel via an un-switched fused

spur, ensuring that the cables enters the housing via its own cable entry point.

Mains Connection

The mains supply is connected to a 3 way "Euro Type" fused terminal block. To comply

with BS4737 the supply should be fed from an un-switched fused spur fitted with a 3A fuse.

All electrical connections should be carried out by a technically competent person and

must comply with the current IEE regulations.

Battery Connection

A 2.1Ah battery must be fitted to the control panel to allow the system to function during

a mains fail condition.

The TSD402 is equipped with a "Battery Protection" circuit so that if a battery is accidentally

reverse connected or its voltage is below 8V, the "Battery Fault" LED illuminates. To clear

the fault simply reconnect or replace the battery as appropriate.

System Installation TSD402 Installation Manual

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Keine Kommentare

Menvier Security TS400 Bedienerhandbuch Seite 12