Menvier Security TS900+ Bedienungsanleitung PDF herunterladen (Seite 8)

Operating The System

Introduction

Initial access to the system is gained by entering a 4 digit passcode. Every time you wish to use

the the system your passcode must be entered correctly. If a passcode is repeatedly entered

incorrectly a code tamper alarm will be generated.

Up to 31 separate user passcodes are available for operating the system. The master user (user

01) is the person responsible for allocating other users to the system.

Each user (02-31) may be defined for different authorisation levels. See page 25 for full details,

the table below shows the code levels and their menu access:

Code level User Menu 1 User Menu 2 User Menu 3

Master

* *

Standard

Holiday

Set Only

Reset Only Options 1-9 only

PA Code

Access Used for access control

Full Set Group Only allows setting and unsetting of selected wards

Code Set Group A

Code Set Group B

Code Set Group C

* If the installation company has programmed the master user for limited access, he or she will NOT have access to

“User menu 2" options 6 and 8, and all options in ”User menu 3".

User Menus

To gain access to the User Menus, first make sure that the keypad is displaying the word “OPEN” to

show that the system is unset. Key in a passcode and within five seconds press [. The system

goes into “User menu 1". (If you do not press [ within five seconds the system will attempt to full

set.) Next, press a key to select an option within User menu 1. On the fold down cover of each

keypad a label shows a brief description of each menu option within ”User menu 1”. See page

17 for more details.

You can abandon any menu option by pressing ] . If you press ] repeatedly after selecting a

user menu then the alarm system will return to the normal “OPEN” condition.

Engineer on Site Message

When the installation engineer attends the site for routine maintenance etc. the remote

keypads may show “Engineer on site” (ENGONSITE), whilst this message is displayed the

alarm system remains fully operational. However, before the engineer leaves the site he should

ask one of the users to enter their passcode followed by ], this will clear the "Engineer on site”

message and return the system to the normal “OPEN” condition.

Operating The System TS790+/TS900+ User Manual

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 56 57

Keine Kommentare

Menvier Security TS900+ Bedienungsanleitung Seite 8