Menvier Security TS900+ Bedienungsanleitung PDF herunterladen (Seite 9)

Full Setting The System

The full setting procedure may be initiated from any remote keypad (if more than one is fitted).

Before attempting to full set the alarm system ensure that all movement detectors are

unobstructed and all doors, and windows are secure.

The installation company will have set-up your alarm system to full set by one of the following:

After entering your passcode the alarm system will be full set after the

pre-programmed exit timer has expired. The display at step (2) will

count down the remaining exit time.

After entering your passcode the alarm system will be full set after the

Final Exit door is opened and closed. The display at step (2) will show a

count of 9999.

After entering your passcode the alarm system will be full set after the

Final Exit door is opened and closed, and after pressing the Exit

Terminator button (a push button normally mounted outside of the

premises). The display at step (2) will show a count of 9999.

Instant

After entering your passcode the alarm system will be full set after 5

seconds.

If an attempt is made to full set the system whilst any circuits are active (such as a door

being open) the display at step (2) will indicate the circuit(s) that are in fault and internal

sounder generates an interrupted tone. The fault must be cleared before the setting

procedure can be completed. If the system is set by "Timed Exit" or "Instant", and the fault

is still present at the end of the exit time an internal alarm will be generated. If fitted, the

external strobe light will flash indicating that the system has “Failed to set”. To prevent this

alarm simply re-enter your passcode before the exit timer expires.

To full set the system proceed as follows:

1. Enter your passcode XXXX. The

display will show:

2. After 5 seconds the exit sounder will start

and the display will show:

3. Leave via the prescribed exit route.

4. The system is set when the exit time has

expired, on activation of the Final Exit circuit

or pressing the Exit Terminator button, as

appropriate. The exit sounder will stop and

the display will show:

5. After 5 seconds the “SYSTEM SET”

message will disappear and the display will

show the time, (date and banner text, LCD

only) e.g.,

Setting Mode: Timed Final Exit Exit Terminator Instant

Exit Time: ________________________

TS790+ & TS900+ User Manual Operating The System

Preparing to Set

Please Wait...

FUNCTION

Func

Please Exit Now.

Time left > 9999

9999

SYSTEM SET

05:30 Sun 28 Apr

SET

ABC SECURITY

05:30 Sun 28 Apr

05:30

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 56 57

Kommentare zu diesen Handbüchern

Keine Kommentare

Menvier Security TS900+ Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Menvier Security TS900+